Pro-Line Supersonic Speed Run Clear Body

From Pro-Line:

Are you looking to convert your Slash® 4×4 into the ultimate Speed Run vehicle? Look no further than Pro-Line’s all-new Supersonic body built from the ground-up to go fast and look good doing it! There is a whole community built around pushing the limits of speed with the Slash® 4×4 (and other SC-based trucks) and the Supersonic body will help you jump right in. Belted tires are a must for going fast and the Reaction HP SC tires and even the Avenger HP 1:8 tires pair perfectly with the Supersonic body! Make sure to get the Pro-Line Extended Body Mounts so you can slam the body as low as possible and wide offset hexes to add even more high-speed stability to your build and to fill out the wheel wells. Get your very own Supersonic Speed Run body today! They are going to go fast!

Supersonic setup shown with (all sold separately):

Slash® 4×4 with Aluminum 17mm Wheel adaper set (TRA6856X)
Reaction HP SC BELTED tires (#10170-203)
Raid 6×30 Removable Hex SC Wheels (#2785-03) using 2.8″ 17mm Hex Adapers (#6336-00)

Features:

Ultimate Slash® 4×4 Speed Run Body!
Designed to Go Fast and Look Good Doing It
Pairs Perfectly with Pro-Line’s Belted SC and 1:8 Street Tires
Made with Crystal Clear Polycarbonate
Use Pro-Line Extended Body Mounts to Get the Body Mounted Perfectly
Add Wide Offset Hexes to Gain Stability and Fill Out the Wheel Wells
Made in the USA, since 1982
Four steps to Speed Run Ready:
1.) Clean Body and apply included window mask
2.) Paint then peel the over-spray film off
3.) Sticker your body (decal sheet included)
4.) Mount your new body onto your truck

What’s Included: